Page 2 – Asimptote

Forum Replies Created

Viewing 9 posts - 16 through 24 (of 24 total)

← 1 2

Author

Posts
October 25, 2022 at 11:03 pm in reply to: Warming / Error #2379

henrique.fragoso da silva
Participant

Hi! The entropy at the outlet is lower than the inlet. The fluid is Helium. I didn’t get to attach the file.

October 14, 2022 at 6:54 pm in reply to: Warming / Error #2320

henrique.fragoso da silva
Participant

Is a compressor. I didn’t put any value to isentropic efficiency. I’m sending a picture.

October 10, 2022 at 6:30 pm in reply to: Warming / Error #2303

henrique.fragoso da silva
Participant

The error is:

” IN EFFICIENCY CALCULATION OF APPARATUS NUMBER 1:
– INGOING PIPE = 20, H = 1180. P = 0.65000
– OUTGOING PIPE = 1, H = 1560. P = 15.000
CHECK THE INLET AND THE OUTLET FOR THERMODYNAMIC PROPERTIES OF STATE! “

October 10, 2022 at 3:17 pm in reply to: NEGATIVE MASS FLOW IN PIPE #2297

henrique.fragoso da silva
Participant

Thanks for the answer. The problem was that the cold fluid was on the secondary side.

September 20, 2022 at 6:29 pm in reply to: Helium Liquefaction System #2191

henrique.fragoso da silva
Participant

Thanks to all of you guys! My system is working now! Thanks!

September 19, 2022 at 9:55 pm in reply to: Helium Liquefaction System #2183
henrique.fragoso da silva
Participant
I am using this system. I think this is the most simple that I did. I didn’t get to do the upload of the file.
- This reply was modified 1 year, 7 months ago by henrique.fragoso da silva.
September 19, 2022 at 8:04 pm in reply to: Helium Liquefaction System #2182

henrique.fragoso da silva
Participant

Thanks!

September 19, 2022 at 6:53 pm in reply to: ERROR_CYCLE TEMPO #2180

henrique.fragoso da silva
Participant

Hi!

If don’t mind…thanks!

September 10, 2022 at 7:55 pm in reply to: Cycle-Tempo discussion forum #2124

henrique.fragoso da silva
Participant

Hi! How to initiate a new topic on the forum? Thanks!
Author

Posts

Viewing 9 posts - 16 through 24 (of 24 total)

← 1 2