Broad use base and number of users both in industry and academia

Friendly, prompt and professional support

Continuously developed in cooperation with leading institutes


Home Forums Asimptote knowledge forum Ways of specifying mass flow rate

Viewing 2 reply threads
  • Author
    • #1785

      Apart from Sink/source (when connected on one side only) and in a valve, is there any way of specifying mass flow rate?
      Also, if DELM is given a negative value, does it make any difference? I did not find any difference when DELM is given a positive or negative value in the simulations I did. Is the software smart enough to decide that DELM can only be positive?

    • #1818

      Yes, these are the only ways to specify a mass flow rate. And, yes, when there is source (sink/source with just one outgoing pipe), then the software always considers DELM as an incoming stream, regardless of whether it is a given negative value.

    • #1829

      Thanks for the clarification Dr. Teus.

Viewing 2 reply threads
  • You must be logged in to reply to this topic.